Folger FT-5 Z Induction Sensor Dual Extrusion
Description
This Is A Remix /Meshmixer Of Two Uploads. Run Ft-5_Z-Bed_Gap.Gcode From An Sdcard After You Have Preheated Your Bed An Nozzle In Order To Set Your Gap. What I Normally Do Is Run Ft-5_Z-Bed_Gap.Gcode And Put A Piece Of Paper Under The Nozzle And Let It Set For 15 Minutes After The First Iteration. After 15 Minutes Pull The Sdcard Out And Reinsert It To Stop The Print. Then Run It Again To Set The Gap. I Do This Before Every Print To Get Best Results. My Gap Is Normally Set Once I Can Get The Paper To Slide Between The Nozzle And The Bed With Just A Little Drag. Sn04 Z Adjuster Hictop 3Dp11: Http://Www.Thingiverse.Com/Thing:1534152 Folgertech Ft-5 Dual Extruder Conversion: Http://Www.Thingiverse.Com/Thing:2138438 I Combined The Z-Base_Rev3(Repaired).Stl To The Ft-5_Back_Plate.Stl. To Allow The Use Of An Induction Sensor With Adjustments. Spring: Https://Www.Amazon.Com/Gp/Product/B015Clfiyo/Ref=Oh_Aui_Detailpage_O09_S00?Ie=Utf8&Psc=1 Induction Sensor: Https://Www.Amazon.Com/Gp/Product/B0052R5Vle/Ref=Oh_Aui_Detailpage_O09_S01?Ie=Utf8&Psc=1 Https://Www.Youtube.Com/Watch?V=Pdkjdi0Tr_W
Statistics
Likes
0
Downloads
0