fischertechnik screw snail with gear
Description
I Have Designed A Fischertechnik Srew From One Piece. At 0.1 Mm Resolution, The Game Is The Same As The Original. At 0.2Mm It Is A Little Heavily Because There Is Almost No Game. So That It Can Be Printed Without Raft I Have Added A 20 Gear. Inside Is A 4Mm Fischertechnik Shaft. Without This, The Screw Is Not Stable. The Transition Between The Gear Wheel And The Screw Is A Fracture Point. Caution When Removing The Pressure Bed. I Have Printed The Snail Up To 30Cm. From 25 Cm It Became Somewhat Unclean By The Movement Of The Nozzle. A Printer With A Firm Print Bed Is Recommended. The Snail I Have Produced In The 30 Mm Grid. I Have Removed 3.5Mm For A Spacer Ring. The Should Be On The Gear Side So That This Can Run Freely. Grid Size: 120 160 200 240 300 Feedback And Change Requests Are Welcome.
Statistics
Likes
12
Downloads
0