remixed idler for infil 3d v2 bowden
Description
This Is My Remix Of The Brilliant Infill 3D V2 Bowden Extruder, I Basically Modded The Idler To Accept A 1/8Th Bsp To 4Mm Pneumatic Fitting To Keep The Filament Straight And Inline With The Hobbed Bolt, Mine Kept Escaping From The Original Guide. I Hope This Of Use To You Guys A Quick Note: What I Did With My Print Was Use An 8.8Mm Drill Bit To Open The Hole Up To Run A 1?8Th Bsp Tap (Borrowed From Dads Shed Lol) Through The Hole But If You Dont Have A Tap The Bsp Fitting Should Beable To Screw In To A 8.8 Mil Hole If Your Stuck Stuck Without This Or Any Other Printed Part My Hub Is Open On 3D Hubs In The Uk My Prusa I3 Is Well Configured And I Stock Abs And Pla Filament. Fell Free To Have A Look At My Hub Https://Www.3Dhubs.Com/Service/221480 Many Thank 5T'S :)
Statistics
Likes
1
Downloads
0