41mm Prop Spinner - for 9" prop
Description
This Is A Minorly Amended Version Redbeardpete'S Efx Prop Spinner, Specifically: * Simplified The Base To Remove Skirt (Which Required A Lot Of Support Material), And To Fill In The Cutout Area Where The Cone Originally Sat * Removed The Bottom Edge Of The Cone Which Would Normally Sit In The Base'S Cut-Out. Now The Pieces Just Sit Flat Instead. Simplifies Printability Further, And Increases Rigidity Of The Base (The Two Screw Fixtures Will Be Sufficient To Hold The Pieces In Alignment). * Increased Prop Hole To Take A 9" Prop. These Changes Mean I Can Use It To Replace My Hyperbipe Spinner (The Stock One Is Foam, And Comes Off Almost Immediately), And Print With A Lot Less Post-Processing.
Statistics
Likes
24
Downloads
0