E3D Ultimaker Direct Titan Upgrade
Description
There Is A New Version: Https://Www.Thingiverse.Com/Thing:2749539 Want To Add A Direct(Ish) Titan Extruder To Your Ultimaker 2? Then This Is For You! You Will Need To Add A Length Of Ptfe (4Mm Od) From The Extruder Down Into The Hot End. I Would Recommend Running A 4Mm Drill Through The Hole In The Titan Fixture. There Are Some Cable Tie Mounts For All The Electronics As They Will Not Fit Through The Head Anymore. Important Note: Remember To Fit The Knurled Long Bolts Before The Motor And The Extruder! 23/03/2017 - Version 2 Is Now Live. Support Has Been Added As The Extruder Was Pushing Itself Up. Printed And Tested. Watch It In Action! Https://Youtu.Be/Oxtv71Bkyuk
Statistics
Likes
94
Downloads
0