Extended high flow fan duct for Anet A8 with autolevel sensor
Description
This Is Version 2: The Distnce To The Nozzle Has Been Reduced And The Airlow In Direction To The Nozzle Was Reduced. This Is A Duct Optimized To Maximize The Air Flow And To Compensate The Additional Diatance Between Fan And Nozzle Due To This Autolevel Sensor Support: Http://Www.Thingiverse.Com/Thing:1911146 Without This Sensor Support The Duct Might Colide With The Nozzle. The Design Is Kept Basic And Simple And Is Easy To Print. No Support Is Needed And The Overhangs Are Limited To 45°. The Flat Area At The Bottom Is Ment To Be The Basis When Printing. A 2.5Mm Hole Is Added To Cut A M3 Theread For A Small Bolt Keep It In Place. The Cross Section Area Is Conciderably Larger Than The Original Stock Duct. Due To The High Temperature Near The Nozzle Best Printed In Abs.
Statistics
Likes
15
Downloads
0