E3D v6 Mount - Suit Anet A8 Fan Ducts
Description
Whilst I Had Been Using Tech2C'S E3D Prusa I3 Mount, I Was Loosing About 15Mm Of Y-Travel, And I Also Didn'T Like The Available Fan Duct Options. I'Ve Designed This Mount With The Ability To Use (Most) Of The Mk8 Extruder Anet A8 Fan Ducts (Semi-Circle, Full-Circle, Mistral Etc) Whilst Still Suiting A E3D V6. In Addition Being Able To Have More Visibility To The Nozzle To Check On Prints. This Design Also Doesnt Loose Any Build Volume. Stl'S Also Contain A Bridge Helper On The Clamping Holes For The E3D Mount, Run A 4Mm Drill Through To Clear Them Out, Or Push Through A 4Mm Bolt And Clean Up With A Hobby Knife. I'M Currently Using Leo_N'S Mistral 2.1, But Other Ducts Should Work Fine. Suits Mounting To The Prusa I3 Rework X-Carriage (Https://Www.Thingiverse.Com/Thing:119616) Or Similar 22.5Mm Hole-Centre Carriage Settings For Marlin #Define X_Min_Pos -14 #Define Y_Min_Pos -13 #Define X_Probe_Offset_From_Extruder 38 // X Offset: -Left +Right [Of The Nozzle] #Define Y_Probe_Offset_From_Extruder 6 // Y Offset: -Front +Behind [The Nozzle]
Statistics
Likes
575
Downloads
0