Fluval FX-5 Canister Filter Lid Retainer
Description
Cracked A Retainer For The Bolts That Hold The Lid On The Fluval Fx5 Canister Filter, So I Designed A Similar Retainer. It Is Not Perfect, But It Works Fine If You Do Not Over-Torque The Bolts. It Should Fit Perfect At A 100% Scale, However I Have A Bit Of An Over-Extrusion Problem At The Moment, So It Worked For Me At 103 And 104% Scale. Did 100% Infill (Lots Of Stress On The Part), Printed It Laying Down Longways With A Brim So Layers Are Perpendicular To The Bolt To Increase Strength, Hope This Helps You! Post Your Make Please!
Statistics
Likes
15
Downloads
0