Aluminatus Corner Clamps With Height Adjuster & 1mm taller clamps
Description
This Is A Remix Of Gkbeers Bed Corners And Clamps. I Added Two Holes So You Can Add A 5Mm X .8 Pitch Adjuster Bolt On The Outer Corner Or On The Inside. My Heater Plate Is A Bit Smaller Than My Glass, So I Chose To Use The Inside Hole. This Adjuster Bolt Will Require You To Drill A Hole At Each Corner. The Hole Size In The Corner Is Such That The Bolt Can Thread In Tightly And Require No Further Hardware To Stay Snug. The F-300 Parts Are The Fixed Pieces That Get Attached And Tightened On The Rear And Along One Side. These Remain Stationary. The A-300 Are Put On The Front And The Other Side And Are Snugged Down Lightly Once Your Glass Or Print Surface Is Level. I Added 1Mm To The Height On The Part That Contacts The Glass. My Glass Has A Rounded Edge And The Extra Height Was Needed For Better Grab. I Also Added A Tiny Angle To The Face Of The Clamping Part To Help If You Have Rounded Glass Edges. It Will Be Fine For Flat Edge Print Plates Also. I Increased The Text Size On The Clamping Parts For Better Readability. (8) M3 X 16Mm .5 Pitch Screws And Hex Nuts Are Needed To Complete A Full Set Of Corners.
Statistics
Likes
26
Downloads
0