Blade Inductrix FPV and FPV Pro Case
Description
Update Feb 24, 2018: I Finished The Carrying Case, Check Out This Thingy Https://Www.Thingiverse.Com/Thing:2814692 New And Improved, And Some Additional Options. Please Note: I Have Uploaded An Fpv Plus Version Of The Case Here: Https://Www.Thingiverse.Com/Thing:2801903 I Have Completely Re-Worked The Files, And Optimized For Printing. I Did A True Offset, So Now The Round Corners Are Parallel. The Walls Are Now 1.6Mm Or 3.2Mm Thick, And If You Print With 4 Shells, They Will Print Solid, And Not Use Infill, Which Makes Them Print Faster. I Have Made A Few Different Versions. I Like The Thicker Walled Version, But Was Also Asked To Make A Thin Walled Version, Which Works Really Well, And Reduced Print Time By More Than An Hour And A Half On My Printer. Here'S An Explanation Of The Different Versions. V22 Fpv Bottom Thin Half Bat - Thin Walled Version With Battery Holders Only 1/2 Way Up. This Is Enough To Hold The Battery In Place, But Further Reduces Print Time. Also Made The Battery Holders A Little Wider, To Hold Thicker Batteries. V22 Fpv Bottom Thin - Thin Walled Version Without Battery Holders. This On My Printer Takes Less Than 3 Hours To Print. V22 Fpv Top Thin Lip - New Version Of A Low Profile Top, To Be Used With Above Version Without Battery Holders V22 Fpv Top Thin Lip Bat - Taller Version Of The New Lid, For The Bottom Using The 1/2 Height Battery Holders. V22 Fpv Top Thin Lip Tall Bat - Extra Tall Version Of The New Lid, For Those Who Want To Print The Bottom With The Battery Holders Like Sebsx, Who Have Really Tall Batteries. I Have Now Uploaded The Thicker Walled Versions, With Are 1.6Mm And 3.2Mm Thick. The Lids Have A 10Mm Overlap, Which Makes Them Fit Really Snug. I Like The Thicker Walled Versions For Stand Alone Cases The Best, But The Thin Wall Work Just Fine, And Print, Much, Much Faster. Enjoy. ---------------------------------------------------------------- This Is My Take On A Carry Case For An Inductrix Fpv. Design Similar To By Rockstaralchemist And Babar121 Http://Www.Thingiverse.Com/Thing:1580567 Http://Www.Thingiverse.Com/Thing:1637219 However, I Made This From Scratch In Fusion 360. What I Found When I Printed The Versions Above, Was For My Fpv, The Fan Cowlings Hit The Battery Compartments. And I Really Has To Press It In, And I Worried About Warping The Fan Cowlings. Also The Spots For The Motors Didn'T Quite Line Up For Mine. So I Just Redesigned It To Make A Little More Room. Also, No Logos, No Fillets For The Top And Bottom So It Prints Easier.
Statistics
Likes
75
Downloads
0