X-Carve 15w Laser Mounting Set
Description
This Set Of Parts Provides A Mounting System For The 15W Ttl Enabled, Focusable Laser From Aliexpress (Https://Www.Aliexpress.Com/Item/High-Power-Diode-Laser-15W-15000Mw-Focusable-Blue-Laser-Module-450-445Nm-With-Ttl-Driver-For/32757380573.Html?Spm=2114.13010608.0.0.03Aszf) It Includes A Laser Holder That Accepts The 40Mm Wide 15W Laser And Allows It To Be Removed So That A Vacuum Hose Can Be Connected To A Dust Boot. The Mount Base Could Accept Other Tooling. The Overall It Also Includes A Mount Plate To Attach The Laser Controller Behind The Z-Axis Motor And A Plate For Mounting The 12V 6A Power Supply To The X-Carve Sideboard. The Laser Holder Is Setup To Use 3 40Mm 12Vdc Fans That Are Wired To The 12V Supply Of The Laser Controller. This Cooling Allows Much Higher Power Levels And Duty Cycles On The Laser. The Power Supply Mount Requires Two M3 X 10Mm Cap Head Screws To Mount The Supply To The Plate And Two M5 X 16Mm Screws To Mount The Plate To The Sideboard. The Controller Mount Uses The Existing Z-Stepper Screws (They Should Have 3Mm Of Available Thread,) To Mount To The Carriage And Two M3 Screws To Mount To The Controller. I Used An M3 Nut On Each Screw Between The Plate And Controller To Act As A Standoff Since The Controller Gets Hot. I Also Added A Strip Of Aluminum Foil Tape To The Top Of The Plate Under The Controller Since I Printed In Pla. Between The Standoff And The Reflective Tape, I Haven'T Had Heat Problems Yet. Print In Abs For Better Heat Resistance.
Statistics
Likes
18
Downloads
0