Prusa i3 MK2 YI Camera holder
Description
Hello ! I Started With This Great Idea And Thing : Http://Www.Thingiverse.Com/Thing:1704137 It Was Already Reworked (Http://Www.Thingiverse.Com/Thing:2010233) But I Had Some Small Remarks On The Design (And Solutions) : -The Screw Was Too Long And The Tread Was Too Small : Very Hard To Put The Nut On If You Print It Fast (0.2) : Smaller Length And Usage Of A Trapezoidal Iso Thread Form, Step 1.5. -The Screw Could Rotate In Its Placement On The Holder : Creation Of A Square Head Screw -The Nut Was Not Easy To Screw : Redesign With Bigger Ears -The Slider Was Too Thin And Flexible : A Bit Thicker To Allow Infill On The Sliding Part -The Holder Was A Little Tight : Dimensions Slightly Enlarged I Used Pla For Holder, Screw And Nut, And Abs For The Slider To Resist On Abs Prints. The First Timelapse Test Result Is Below On The Video
Statistics
Likes
22
Downloads
0