Semi circular fan duct for Tech2C E3D V6 X-carriage
Description
Update 28.3.2017: - Added A By 2Mm Reduced Version Which Should Fit The Original E3D V6 Also. Distance Between Center Screwholes And Top Is Still The Same. Cut Was Made Within The Lower Part. So This Is My Very First "New Thing"..I Am Always Open For Criticism, So Fell Free I Printed Tech2C´S "E3Dv6 Bowden X-Carriage Mount V2 For Prusa I3" (Http://Www.Thingiverse.Com/Thing:1632847) Which Is Great, But The Fan Duct Is Blowing Onto The Nozzle (E3D Clone With Peaking M7 Thread, So It Is Longer Than The Original One) And That, In Some Cases, Caused The Filament To Cool Down Within The Noozle At Times When The Fan Was Above 60%. And I Wanted To Adapt The Semi Circular Fan Duct (Used This Http://Www.Thingiverse.Com/Thing:1954001) To This Setup. So I Combined Both, The Integrated Tech2C Fanduct With The Semi Circular End Made By Lokster And Others. As Sensor Mount I Recommend This With A 10Mm Offset Http://Www.Thingiverse.Com/Thing:1639085
Statistics
Likes
149
Downloads
0