Screwdriver bit for step drill
Description
So I Needed To Drill A 1/2 Inch Hole To Make Some [Airtight Filament Canisters](Https://Www.Thingiverse.Com/Thing:1332650) But I Had No Power Tools For My [Step Drill](Https://Www.Amazon.Ca/Bosch-Sdh1-Speed-Steel-Drill/Dp/B000Cfnbdq/Ref=Sr_1_4?Ie=Utf8&Qid=1481048751&Sr=8-4&Keywords=1%2F2+Step+Drill). So I Designed A Screwdriver Bit To Hold The Step Drill =) It Can Be Very Strong When Printed With 80% Infill. However, You Must Apply Pressure Correctly (I.E. Not On The X/Y Axis) Or It May Break. Also, I Suppose You Can Drill Harder Materials But It Will Take Much Longer. It Was Great For Soft Materials Like Plastics! **Also, This Is Made To Be Tight Fit So The Step Drill/Screwdriver Bit Doesn'T Fall Off By Itself. Lower The Scale If It'S Too Tight For You.** =)
Statistics
Likes
2
Downloads
0