Tinker-Friendly Parsons Table Enclosure
Description
This Is A Remix Of The Tinker-Friendly Lack Enclosure Designed By Zuspiel. It Is Designed For Mainstays Parsons End Table. Because The Table Itself Is Smaller In The X And Y, My Anet A8 Will Have To Be Installed At A 45-Degree Angle To The Table. Because The Legs Also Incredibly Short, I Had To Lengthen The Extention. Once Printed, The Dimensions Appear To Be *Almost* Right, But It Requires A Tiny Bit Of Pressure To Seat, And There Was A Noticeable Seam. I Did Not Personally Mind It, But If The Diameter Of The Knob On The Top Half Were Reduced By A Millimeter Or Two, It Would Make It Pretty Seamless. The Finished Setup Utilizes Yoga Mat Material, And I Have Used Some Brackets (Http://Www.Thingiverse.Com/Thing:2001275) To Hold It Down And Help Reinforce The Frame.
Statistics
Likes
17
Downloads
0