Nintendo Switch Hylian Shield Stand
Description
I Loved The Nintendo Switch Stand That I Saw Scrolling Through Thingiverse, But Being The Zelda Fan I Am, I Decided That It Needed Some Custom Logo On It. So, I Did Just That. Edit: I Added Air-Intakes In The Back Of The Stand For The Air-Intakes On The Back Of The Switch. Source: Http://Www.Thingiverse.Com/Thing:2157876 Note: Place It On Its Side To Print It, As Done In The Picture Above. Printer Settings: Layer Height: .25 Fill Density: 50 Note: Can Be Done At 15-25 Infill. But Being That The Switch Is A Very Expensive Machine, I Wanted A Bit Of Security So I Bumped Up The Infill. Supports: No Support Diameter: 1.75
Statistics
Likes
34
Downloads
0