FreeTrack Cap Point Model
Description
This Is A Cap Style Point Model For Use With Opentrack, Freetrack, Or Facetracknoir. It Is Designed For External Power, Either Via Usb Or A Battery Pack. Check Out The Serial Build Guide On The Freetrack Forums Here: Http://Forum.Free-Track.Net/Index.Php?Showtopic=1856 Pointmodel Dimensions Are 80Mm Side To Side (40Mm From Centerline), 60Mm Up, 90Mm Back. Design Is Based Around 0.3Mm Layers For Speed, But Any Layer Height <=0.6Mm Should Work Fine. Print Flat, Trim And Assemble As Needed. Put Some Hot Glue In The Corners To Stiffen It Up And Lock Everything Down, Then Wire Up. I Used Some Heatshrink Around The Leds To Hold Them In Place After Wiring, But Hot Glue Would Work Fine - They'Re A Pretty Tight Fit By Hand To Begin With, So They Don'T Take Much To Stay Stuck.
Statistics
Likes
7
Downloads
0