Replacement Ceiling Mounting Plate for the Ubiquiti UniFi AP-AC Lite and AP-AC LR

Description

**Important Note:** I Recommend Printing This Mount With A Heat-Tolerant Filament, Such As **Abs Or Petg**. If Printed With Pla, The Current Model May Slowly Deform Due To The Heat Underneath The Ubiquiti Unifi Ap-Ac, And It Could Fail After A Few Days. I Am Currently (January 28, 2019) Testing A Model With Vents To Help Release That Heat And To Prevent The Pla From Slowly Melting. I Will Post The New Model Once I'M Convinced It Will Work For Pla. This Is A Replacement Ceiling Mounting Plate For The Ubiquiti Unifi Ap-Ac Lite And The Ubiquiti Unifi Ap-Ac Lr. (Tested On The Lite Model Only, But The Lr Supposedly Uses The Same Mounting Plate.) Unfortunately A Mounting Plate Was Lost During Some Renovations, So I Decided This Was A Good Opportunity To Learn Some Fusion 360. :-) This Mounting Plate Is Close To The Original In Dimensions, With The Notches Are A Bit Wider To Make It Easier To Get The Ap Into Place. The Locking Bar Has A Very Prominent Slope On It To Help Lock It In Place Easily. There Are Two Versions: A Thinner One And A Thicker One. This Model May Lack The Carefully Engineered Plastic-Saving Ridges Of The Original, But It Makes Up For That With A Low Infill Percentage. The Main Thing Is That It Does The Job. :-) Depending On Feedback, I Might Change The Locking Bar. In The Original It'S Actually Offset "Upwards" A Bit From The Way It Is In My Model. However, The Long Slope On The Locking Bar Edge In My Model Makes It Easy To Lock Into Place. This Model Worked For Me, So I Haven'T Had A Need To Modify It Further. :-)

Statistics

Category

Tags