Prusa Parts
Description
Various Parts That I Have Printed To Fit My Printer. Im Not Sure On What Design My X Carriage Is, So Ive Been Measuring And Then Adjusting To Fit. Yendstop: The Holes Are At 19Mm To Fit A Makerbot Endstop. New Version Of Endstop Bracket (Differnt To Photo): About 4Mm Lower To Accommodate A Thinner Build Plate That Im Now Using, Thickened Some Places, And Now Printing It On Its Side Using Support. Modified Bar Clamp: Hole Is Bigger To Slide On Easier. Also Beefed It Up A Bit. Fan Mount: Has To Be Printed In Two Halves And Then Glued Together. I Increased The Surface Area That Contacts The Build Plate To Prevent Lifting. The Mesh Is Messy Where Those Tabs Are, But It Slices Correctly. Zend Stop Servo Bracket: Nothing Special. Light Bar: Just For Stick On Strip Leds
Statistics
Likes
6
Downloads
0