.5 nozzle Dual extruder offset tuning tool
Description
The Original Is Great! Very Simple And Easy To Use. However, It Doesn'T Work For .05 Nozzles Or Smaller Beds Like My Moneprime Thats 180 On The X. So I Imported This Into Onshape, Cut Of The 4 Notches On The Ends And Imported It Into My Slicer. There I Resized Only X And Y By 125% So That It Works On A .5 Nozzle. Note, This Does Throw Off The Original Scale Of .05+/- Per Mark From The Center. At 125% Scale It'S Now .0625 Per Mark. Even If You Use .05 Per Mark, You'Ll Be Fine As The Difference Of .0125 Is Not Noticeable Unless You Have Super Eye Powers! Even At 10 Marks That Adds Up To A .125 Which Is Just Slightly Thicker Than A Sheet Of Paper. In Which Case, You Just Run The Test, Adjust, And Run Again. These Only Take 4Min To Print.
Statistics
Likes
1
Downloads
0