Anet A8 Filament Guide - Extruder Mounted
Description
So I Took A Couple Of Other Thingiverse Mounts To Make This. The Problem I Had Was My Chain Was Rubbing On My Filament. So I Pieced Together A Couple Of Other Creations And Came Up With This. Im No Cad Pro So Its A Little Rough. But It Works. I Little Tough Reloading Filament Around This But I Have Improved My Procedure And Now Its No Problem. You Will Have To Adjust It In Your Slicer For Best Print. I Did It On Its Side With The Tube As Close To The Bed As Possible And Use Support Up To 4Mm Then Turned Support Off So It Didnt Fill The Tube With Support Material. I Used Simplify3D.
Statistics
Likes
1
Downloads
0