dt750 yaw mount
Description
After Searching A Lot For The Perfect Yaw Mount I Decided To Design Me One. I Got Solidworks, So I Should Draw Something. After A Crash With An Bad Mount I Got Something To Draw! It'S Designed For A Tricopter Using 12 Mm Booms, Dt750 Motors And A Bms-620Mg Servo. Use Epoxy Or Another Strong Glue To Mount The Mount To The Servo Axle. Be Sure To Not Glue The Mount To The Servo Case, So Use Only A Small Drop Of Glue. To Mount The Motor To The Mount, I Used 4 Mm Zip-Ties. I Used The Same To Mount The Mount And The Servo To The Frame. Note: The Bottom Piece Of The Mount Is Not Symmetric! When Used In The Correct Direction It Should Turn Smooth. I Used A 3 Mm Shaft To Turn Around. Drill One Time Through The Holes Of One Part Of The Mount.
Statistics
Likes
0
Downloads
0