Pegboard Insert Screwdriver Holder
Description
I Made This Insert Out Of Frustration After The Only Screwdrivers I Had Would Fall Right Through The Rings On Pegboard Screwdriver Holders And Get Stuck. These Inserts Hold Either 1 Screwdriver In The Middle, Or Two Smaller Ones Side By Side In The Same Ring. The Small Holes Have A Diameter Of 0.2 Inches, And The Large Center Hole Has A 0.32 Inch Diameter. The Inserts Fit Into Standard Circular Pegboard Screwdriver Holders With ~3/4" Rings. A Small Bump On The Bottom Holds The Insert In Place So It Doesn'T Pull Out. Video Of How Useful It Is At: Youtube.Com/Watch?V=7Loxfjke7Hg I'M Sharing This For Your Own Use. If You Want To Sell This Commercially, Please Contact Me First. I Have A Slightly Different Version Better Suited For Printing From Nylon Available To Buy On Shapeways At: Https://Www.Shapeways.Com/Product/T4Zafrt6H/Screwdriver-Holder-Insert
Statistics
Likes
17
Downloads
0