Universal Outernet Case for the DIY Kit (Any elevation angle)

Description

This Is A 3D Printable Case For The Outernet Diy Kit. It Can Be Used For Any Satellite Elevation Angle. The Case Is 15,3Cm (6") Tall, 13.6Cm (5.35") Wide And 4.4Cm (1.73) Thick. The Sdrx And Chip Mini Pc Can Be Screwed To The Main Part Of The Case. They Will Be Connected To Each Other Over A Short Usb Cable (Micro Usb To Type A / Charging Cable).The Patch Antenna Just Slides Into The Case. The Stand Is Screwed Into The Two M3 Nuts That Are Placed In The Main Case. The Elevation Angle Will Be Set Trough Tightening The Scrwes After Positioning The Case In The Right Angle. Discussion And Any Suggestions On The Outernet Forum: [Universal 3D Printable Case](Http://Forums.Outernet.Is/T/Universal-3D-Printable-Case-For-The-Diy-Kit-Sdrx/3457) You Need The Following Additional Parts: - Two M3 Screws And Nuts - Two Micro Usb Cables (Short Ones Will Work) - Micro Usb Extension (Optional For A Socket In The Back, Replaces One Usb Cable) - 30Mm 5V Fan (Optional For Cooling) - A Sheet Of Plexiglass Or Acrylic (Optional, 130X125Mm 4Mm Thick Or Less)

Statistics

Category

Tags