Universal Filament Spool Holder
Description
This Thing Is A Remix Of Two Already Published Solutions For A Filament Spool Holder, So First Of All The Honor Goes To The Two Guys Who Did The Basic Designs: Http://Www.Thingiverse.Com/Thing:52927 Http://Www.Thingiverse.Com/Thing:467008 I Liked Both Designs, And As The Spool Ends Of The "Simple Holder" Did Not Fit Perfectly To The Spools I Wanted To Use, I Thought Combining The Stands Of This Solution With The "Spool Holder With Bearings" From The Other One Would Lead To A More Universal Solution. To Reach This Only A Small Modification Was Necessary: - The Spool Ends Themselves Are Taken As They Are - I Did Not Modify Them At All, Being Designed For 6Mm Bearings (17X6X6). - The Spool Holder Stand Then Did Not Fit To The Spool Ends - It Was Designed For 8Mm Threaded Rod Originally. So I Changed The Size Of The Hole To 6Mm, The Whole Filament Spool Holder Now Consists Of The Following Components: - 2 Printed Stands - 2 Printed Spool Ends - 4 Bearings 17X6X6Mm - 1 Threaded Rod, Length 300Mm (The Length Depends On Your Requirements) - 4 Normal 6Mm Nuts (I Put Two On Each Side Of The Spool Holders To Avoid That They Losen During Operation) - 2 6Mm Wing Nuts - 6 6Mm Washers - Some Anti-Slipping Stickers For The Bottom Of The Stands To Avoid The Holder Moving Around During Operation. The Spool Holder Should Work With Very Low Friction And (Hopefully) Fit To Almost Every Type Of Filament Spool.
Statistics
Likes
14
Downloads
0