Extruder Light
Description
Have A Problem Seeing What You Are Printing? Need A Way To Get More Light On Your Extruder Nozzle? I Always Had To Use A Flashlight To Try And Follow The Extruder Nozzle Around. Most Of The Time I Was Way To Slow, By The Time I Moved The Flashlight The Nozzle Had Moved Again. Finally Decided To Mount Some Leds Near Or On The Extruder. This Is A Remodeled Blower Mount With A Place To Hold A Printed Circuit Board With Three Jumbo Leds. The Printed Circuit Board Will Also Hold The 200 Ohm Led Current Limiting Resistor. All The Inter-Connecting Wiring Will Be Inside The Shelled Out Area Behind The Printed Circuit Board. Power Comes Directly From The 12 Volt Power Supply (Or Through A Switch If You Want) Wanted: * More Light * Always Shining On Nozzle Edge * Not Obstructing The View On The Left Side (I Sit Slightly Off To The Left Side Of The Printer) Updated 4/6/2017 For Those Of You That Want To Change From The Existing Blower Fan To The Typical 40 Mm Fan For Part Cooling, Use New Stl File: Blower Mounting With Led Mount With 40Mm Fan R1
Statistics
Likes
8
Downloads
0