LCD Snake or Eerie Eyes Bottom Case with Cutout
Description
There Are Two Really Cool Projects Done By Phillip Burgess On Adafruit [The Animated Electronic Eyes For Teensy](Https://Learn.Adafruit.Com/Animated-Electronic-Eyes-Using-Teensy-3-1) And The [Animated Snake Eyes For Raspberry Pi](Https://Learn.Adafruit.Com/Animated-Snake-Eyes-Bonnet-For-Raspberry-Pi). Especially On The Rpi/Bonnet Project, More Wires Are Required And It You Use The Plug Connectors, There Didn'T Seem To Be Cut-Out Space For The Plug Connectors Where They Come Out The Back With Phillip Burgess' Design: [See Picture At Link](Https://Learn.Adafruit.Com/Assets/38347). In The Teensy Design, There Were Fewer Wires, So You Just Solder And Thread Them Out Through A Little Gap He Wisely Included. In This Adaptation, I Cut Out Enough Space (Imo) To Allow The Plug Connectors To Come Out The Back. I Took This As A Challenge To Adjust The Original Design. This Was A Very Helpful Process As I Had To Learn A Little Bit To Use Tinkercad. My Humble Appreciation For Pburgess Work In The Adafruit Community And For Making This Freely Available. He Deserves Any Tip You Might Consider.
Statistics
Likes
5
Downloads
0