18mm inductive probe mount for Prusa I3 clone
Description
The Typical 8Mm Diameter Inductive Probe Has Such A Small Detection Range And It'S Difficult And Expensive To Acquire Prusa'S P.I.N.D.A. Probe. The Larger 18Mm Diameter Probes Have A Much Larger Detection Range So You Can Keep The Probe A Lot Higher Than The Print Nozzle. Remove The Four M3-18Mm Screws From The Extruder Fan And Mount This Part Using Four M3-25Mm Screws. Don'T Forget To Enable Z_Safe_Homing In Configuration.H In The Marlin Firmware.
Statistics
Likes
4
Downloads
0