Trinket Bottle
Description
When Printed Please Take Time To Sand Down Or File Down The Edge Of The Vial, Not The Lid, Just The Vial'S Outer Edge Because If You Try To Put It Together And Close It It Will Lock On You Because When Printing 3D The Lines May Be Sticking Out(You Can Hit Up The Inner Of The Lid If You Really Need Too)...The Fraction Sticking Out Is Micro, But Will Lock The Lid On And Will Be Hard To Remove Because The Measurements Were So On Point...So Please Use Sand Paper Or A File To Take A Bit Off The Rough Edges And Enjoy Stashing Away For The Trip ;)...
Statistics
Likes
11
Downloads
0