Reef Ball Pirate Coin (Copper)

Description

This Is Designed To Be Printed In Copperfil Or Bronzefil (Colorfab). Bring Into Your Slicer Then Size According To The Coin Size You Want....It Starts Out As 1 Cm So If You Wanted 3 Cm Diameter Scale To 3X. Scale Large Enough To Get The Detail You Want Out Of Your Printer Resolution Head Size And Layer Height. A Good Setting For Me On The Lulzbot Mini Is 3X, .2 Mm Layer Height, 200C Print Temp, 60C Bed Temp, 25Mm/Sec Print Speed No Support Or Adhesion. After The Coins Print, There Are Two Methods To Glue...Use Seal All Glue Or If You Are Good With A Blowtorch Lay The Side With The Subliminal Rb On It On Tile Face Down And Hit It With A 2 Second Blast Of Flame Then Take The Other Half And Set On Top Face Up. Press Together Gentle And Allow To Set. After Either Glue Method, Take A Soildering Iron And Go Around The Edges To Seal Up And Eliminate The Seam. Finally Toss The Coin In A Glass Of Bleach (Chlorine) And Leave A Day Or Two....Speed It Up By Pulling It Out And Letting It Dry A Few Times During That Period. When The Coin Has The Patina Of Being In The Sea For Centuries, Then You Can Preserve It With A Coat Of Non-Glossy Polyurethane Paint/Sealer Or Just Leave It As Is. Enjoy And Spread The Word About Reef Balls To Help Save And Create Marine Habitat.

Statistics

Category

Tags