RepRap Ormerod extruder modyfication
Description
If You Want To Move Your Extrude Motor Next To Hot-End This One Is For You. I Used A Part Of Original Bracket As I Had Limited Options To Print New High Quality Parts. I Needed To Bend My Bracket A Bit, Because It Was To Close To Acrylic X-Axis Element. You Will Need To: - Cut And Drill Extruder Body. - Drill And Thread Radiator, To Fix The Bracket (Difficult Part). - Drill A Hole In X-Axis Acrylic To Fix Your Bracket. - Trim Plastic Pipes To Proper Length. - 2, 2.5 And 3Mm Drill Bits Will Be Needed. Additional: - Rise X-Axis Current To 1000Ma (Oryginal 800Ma) In Config File On Sd Card Or Use Lower Speed - Mount Extrude Motor With Connector Pointed Up What You Get: - Much Higher Objects Quality (Limited Stringing) - Faster/Easier Filament Load (75Mm Instead Of 420Mm) Model Is Made In "Creo Parametric" 3D Software.
Statistics
Likes
2
Downloads
0