Replicator 2 Platform Stilts
Description
My Build Platform Was Nearly Exactly 1Mm Too Low, And It Was Causing Some Trouble Printing Stuff Near The Back Of The Platform, Where The Filament Cooling Fan Duct Would Bang In To The Sprung Plastic Hook That Holds The Platform Down To The Tripod. The Best Solution I Could Find Was To Add Feet To The Platform Itself, Just Above The Soft Rubbery Pads On The Tripod, Lifting The Platform Up 0.95Mm. The Feet Are Rather A Lot Larger Than They Need To Be. I Eyeballed The Design, So I Left Lots Of Room For Mistakes, But It Does Work Really Well!
Statistics
Likes
9
Downloads
0