ANET A8 Complete set E3D V6 Direct Drive with Clamp, Fan Duct and 18mm Sensor
Description
Havent Touched The Mount Itself Just Added The Fan Duct And Hotend Clamp. I Printed It At .3 Initial Layer .25 Layer Height 35% Cubic Subdivision Infill Support From Bed Only At 50 Mm/S Should Probably Add Dont Print It Out Of Pla If You Want It To Last Can Be Printed All Together On The Build Plate Of Anet A8 In One Go File 2 Includes Heatbrake Duct For 40Mm Fan Make Sure Heatblock Has Heater Cartidge Towards The Rear Of The Printer Or You Will Melt Holes In The Fan Duct Your X And Y Home Offsets Will Change With This Mount It Is Now -16 For X And -8 For Y
Statistics
Likes
43
Downloads
0