Desktop lamp
Description
I Found Unused 3 Watt Leds And Decided To Design A Desk Lamp Useful For Soldering Plates And Other Fine Work. This Lamp Was Designed In Software Moi 3.0. Lamp Height 26 Cm. In Addition, I Used : - 2 X M3 12 Mm - 2 X M3 6 Mm - 2 X Nuts M10 The Nuts Serve As The Underlay Load (You Could Use Something Heavier It Would Be Better) - 1 X Dc-Dc Converter (Step Dwon) - 1 X Switch - 1 X Power Socket - 1 X Power Supply 12 V 1A The Heat Sink For The Led I Made Of Three Aluminum Slats 120 X 30 X 3 Mm . I Glued The Leds To The Aluminum Conductor With Heat-Conducting Adhesive. The Heat Sink Was Attached To The Lamp On Silicone. Leds Are 3 Watts - 10 V 0.3 A, Connected In Parallel. I Set A Bit Lower Voltage ( 9.6 V) So That The Consumption Does Not Exceed 0.5 A.
Statistics
Likes
7
Downloads
0