Flynoceros Canis M5 Cerberus Custom Parts
Description
Flynoceros Canis M5 Cerberus Custom Parts Several Parts I'Ve Designed For One Of My Favorite Frames... 3 Position Camera Mount: Positionable @ 25, 40, And 55 Degrees. Fits Hs1177, Runcam Swift, Etc. Accepts Lenses With ~17Mm Outside Diameter. (Stock Runcam Lenses Probably Wont Work) Fixed Camera Mounts: These Are Slightly Tweaked Versions Of Josh From Flynoceros Original Designs. I Use An Hs1177 And Wanted A 25 Degree Mount That Was Compatible With My Camera/Lens. Later Made A 40 Degree Version As Well. These Are Designed To Also Work With My Tray Designs. Battery/Protective Trays: A Few Variants Of These. Original Design Was For Top Mounted Battery W/Rx Antenna Holes. Newer Version Has Mount For Unify Pigtail Included. Another Version Has Same Unify Hole, But With A Notch That Matches Up W/ My Gopro Session Mount. I Found The Matched Notches Helps With The Session Mount From Sliding Around. Gopro Session Mount: Universal Design With Tie Wrap Holes Will Fit On Any Flat Mounting Surface. Also A Version With A Notch That Works In Conjunction With My Tray Design To Stop Camera From Sliding Around. Vtx Mount: Designed This To Fit Between The Vertical Frame Rails On The Canis. Uses The Frame Bolts And Frame Notches As Mounting Support In Addition To A Tie Wrap Near Base Of Vtx And Antenna Nut. Designed Specifically For Lumenier Vtx, But Will Definitely Accommodate Models With Similar Dimensions. Print From Tpu (Preferred) Or Pla.
Statistics
Likes
8
Downloads
0