TEVO Black Widow Y-axis tensioner
Description
My Own Take On A Y-Axis Tensioner For Black Widow, Didn'T Want To Just Make It Look Like A Square Industrial Block, If You'Re Already Doing Something - Do It With Style ;) It Uses Already Existing Screws, Pulley And Washers That Are Used On Bw, One Item You Will Need Is A Single M6 Screw (25Mm~30Mm) With A Nut, Slots For Both Are Already Incorporated Into Parts. I Have Designed The Screw Holes A Little Tight, Personally I'M Using A Drill To Adjust The Holes Post Printing On Most Occasions For A Smooth Tunnel, Otherwise You May Need A Bit Of Force To Drive The Screws Through. Have A Vision Or Two How To Improve It A Bit More, But It Works As Intended In Its Current State Already. Keep In Mind The Limits Of Your Hardware! The Belt, Held In Many Cases Only By Teeth Facing Each Other Pressed Together By Cable Ties Can And Will Slip Out If Pushed Too Far (It Did For Me On First Try!), So That'S Your First Limit To Consider - And Don'T Forget, On The Other End You'Re Applying This Pressure Directly To The Shaft Of The Motor, So Use Common Sense Please. Enjoy!
Statistics
Likes
131
Downloads
0