Dial Gauge Mount extruder motor MP Maker Select v2
Description
This Is A Snap Together Dial Gauge Mounting Bracket For My Monoprice Maker Select V2.1 So It Should Work Well For Any Number Of Wanhoo Duplicator I3 Clones... I Was Tired Of Using The Standard Bed Leveling Process And Decided To Go Through Pages Of Auto-Level, Feeler Gauge Leveling, And Dial Gauge Leveling. I Wasn'T Happy With Any Of The Existing Mounting Options For A Dial Gauge And The Selection For The Maker Select Was Quite Limited. I Liked The Induction Sensor Mounted Location Off The Right Side Extruder Motor But Only One For A Dial Gauge Existed In My Search, May Be More Now, And The Dial Was Facing To The Right. I Created This So That The Dial Faced Forward. The Two Pieces Fit Together Pretty Snug But A Drop Of Super Glue Will Hold Them Together If They Should Loosen Over Time. The Square (Fan) Portion Attaches On The Motor And The Round (Gauge) Portion Around The Dial Gauge. On My Dial Gauge Off Amazon, Neoteck Dti Digital Dial Indicator 0.01/.0005'' Digital Probe Indicator Dial Test Gauge Range 0-25.4Mm/1'' Dial Test Indicators Electronic Indicator Gauge, I Have Just Under 2Mm Of Clearance When Zeroed On Full Extension. So There Is At Most 2Mm Of Possible Collision With The Print. I Use A Twist Tie To Hold The Feeler Up If I Think It Will Hit The Print.
Statistics
Likes
99
Downloads
0