Tiny Whoop AND Kingkong Tiny7 Launching Pad
Description
##***Whoop!***## Racing Style Launching Pad For Tiny Whoop, Blade Inductrix / Clones And Kingkong Tiny 7 Brushed Quadcopters. Launching Your Quad In A Canted Forward Position Allows Starting At A Higher Speed, Eliminating The Need Of Climbing Before Gaining Forward Speed. **Features:** - Ball Joint Design Allows Pivoting Up To Approx. 20 Degrees In Any Direction. - Thin Arms Prevents Unintentional Lifting Your Quad By Ground Effect, Especially From Idle Speed / Air Mode. - Dimple Shaped Recesses Provide Just Enough Retention Without "Sinking" Too Deep Into The Launching Pad. **Update:** - **31 Oct 2017** - Modified Ball/Socket Geometry For A Stiffer Joint. - Tweaked Motor Dimple Positions To For Better Fitting. **Notes:** - Launching In Extreme Angle Can Be Problematic If Your Quad Is In **Angle / Horizon / Auto-Leveling Modes**, Launching In **Acro / Rate Mode** Is Recommended, Or Just Do The Whole Race In Acro, It'S Challenging And Fun! - **Test Ability To Arm Before Flight!** Default `Small_Angle` Value In **Betaflight** Allows Arming If Your Quad Is Canted Up To **30 Degrees**, Decrease Cant Angle Or Increase `Small_Angle` Value If You Have Trouble With Arming Your Quad. - Print Upper Part Upside Down For Easier Print. - Recommended Print Settings: 20% Infill, 5/5/3 Top/Bottom/Perimeters For 0.4Mm Nozzle At 0.2Mm Layer Height. - Feel Free To Report In Comment Section If You Encounter Any Issues With The Design. **Flying Tiny Whoop Exclusively? Use This Instead:** Http://Www.Thingiverse.Com/Thing:2245982 Https://Youtu.Be/C7G4Bjcw44S
Statistics
Likes
83
Downloads
0