AR Drone 1.0 Replacement Landing Gear
Description
I Landed Hard On The Ground Last Fall And Snapped Off One Of The Landing Gear. I Tried To Glue It Back On But It Only Took A Little Harder Then Normal Landing To Snap It Off. I Found The Landing Gear By Pink_Iguanas But Could Not Figure A Good Way To Glue It On. I Made A Snap On Piece For The Cross Beam And Then Added The Flat Top At The Exact Height To Make The Drone Level. I Printed Them As One Piece But Found That The Support Messes With The Ability To Snap On. So I Split The 2 And Glued Them Together After Printing. Update This Will Work With 2.0 As Well. I Have Verified This. Disclaimer Please Note: I Made The Clip To Be Very Tight. If You Want To Take It Off Do So With Care. If You Force It You May Damage The Cross Beam And I Have Not Seen A 3D Printable Version Of The Cross Beams.
Statistics
Likes
35
Downloads
0