Falcon 250 pro cross-frame antenna holder
Description
This Is A Receiver Antenna Holder For The Falcon 250 Pro. It Secures Both Coaxial Antenna Leads At 90 Degrees Apart, Keeps Them Away From The Props And Keeps Them Away From The Fpv Transmit Antenna, So The Rc Range Is Less Compromised By Interference From The Fpv Transmitter. It'S Designed For 3Mm Frame Holes, 34Mm Apart And Nicely Fits Behind The Camera Platform And In Front Of The Battery. You Will Need To Lift Off The Top Panel To Turn The Receiver Around And To Route The Antenna Leads. Don'T Crimp The Leads Between Surfaces And Don'T Bend Them Too Tightly. While You'Re Removing The Panels, Take The Time To Put Some Insulating Tape Between The Bottom Of All Side Panels And The Base Plate. The Pcb Is Badly Designed And After Time And With Vibration The Carbon Fibre Panels Rub Through The Insulation On The Pcb And Short Circuit The Tracks. These Just Happen To Be B+ And B-, Which Causes Erratic Flying, Excessive Current And Bits Of Carbon Fibre Catching Fire. Invest The Time, You Will Thank Yourself. Print And Enjoy.
Statistics
Likes
6
Downloads
0