ANET A8 E3D carriage
Description
Light And Sturdy Carriage For Anet A8 Converted To Bowden E3D Extruder. You Can Select Of Variety Clamps With Fan Mount And Round 8Mm,12Mm, 17Mm Cubic Inductive Sensors Or Without A Sensor Or Just A Bare Clamp For Setups With Fan(S) Attached To E3D Hot End Directly. It Looks Awesome If Printed Of A Temperature Dependent Color Changing Filament. Check Out My Other Stuff For Anet A8 And Enjoy!. Fitting: It Uses Original Setup - Bolts And Nuts To Attach X- Belt, But Positioned Slightly Higher To Make The Belt Run Linearly. It Has 6 Attachment Points For Zip Ties. The Clamp Is Attached With Two M3 Bolts And M3 Nuts Fitted In Carriage Slots For Tight Fit. Print Setup: Clamps - Print Upside Down, 50-100% Infill 1,2Mm Walls, No Supports Carriage - 50% Infill, 1.2Mm Walls No Supports Nozzle - Print Solid, With Supports Touching Buildplate Only Material - Preferably Abs, But Pla Works Fine For Carriage Too For Open Setup. 29/4/18 Configuration.H File For Marlin 1.1.8 Attached Run Pid Calibration Of Display After Instalation And Tune Your Z Offset Calibration: In Configuration.H: Define X_Max_Pos 220 Define X_Min_Pos -16 Define Y_Max_Pos 220 Define Y_Min_Pos -9 Define Z_Max_Pos 240 Define Z_Min_Pos 0 Define X_Probe_Offset_From_Extruder 30 // X Offset: -Left +Right [Of The Nozzle], For Tsd E3D V5 Carriage Define Y_Probe_Offset_From_Extruder 0 // Y Offset: -Front +Behind [The Nozzle] Define Z_Probe_Offset_From_Extruder 0 Define Abl_Grid_Max_Points_X 3 Define Left_Probe_Bed_Position 20 Define Right_Probe_Bed_Position 200 Define Front_Probe_Bed_Position 20 Define Back_Probe_Bed_Position 200 Define Z_Safe_Homing Versions: Clamp Bl Touch - !Prototype! Please Test And Comment Clamps V6H And V6J - Prototype For "Anet" Blue Cubic Z Sensor Fan Nozzle 5H - Optimized High Flow Nozzle Clamps V6E And V6F - For 17X17Mm Cubic Sender Like Tronxy Or Prefered Tl-Q5Mc1(Works Great At 5V ~4Mm Sensing Distance). V6E Is Attached By Two M3X25Mm Bolts, V6F Is Fixed By A Zip Tie. Calibration X +30Mm (Right) Of The Nozzle. Clamp V6D - !Prototype! For 12Mm Inductive Sensor, Calibration X +30Mm (Right) Of The Nozzle Clamp V5B No Fan - Optimized Bare Hot End Without A Bracket For A Fan Nozzle V5 - High Flow Nozzle Clamp V5 - Optimized Clamp For 8Mm Inductive Sensor, Calibration X +30Mm (Right) Of The Nozzle Note: Please Leave A Feedback And Proposals In Comments.
Statistics
Likes
146
Downloads
0