Water drip irrigation nozzle
Description
A Water Drip Nozzle Made To Fit The Barbed Adapter I Made Recently. The Part Got 0.3Mm Clearance For The Adapter. In The Design The Hole On The Nozzle Is 0.9Mm In Diameter, Though It'S Probably Smaller Than That After Printing. This Is Pretty Much A Permanent When Added Due To The Short Clearance, So Be Sure To Make It Go Through The Same Steps As On The Original Adapter To Make It Waterproof And It Might Help To Glue The Two Parts Together. After You Push It Into The Adapter It'S Hard To Remove Again, Push It As Far As Possible, The Adapter Got A Small Notch That Can Catch The Nozzle. If You Try It, Please Tell Me How It Works. I Haven'T Actually Worked With Drip Irrigation Before Now So Any Feedback Would Be Nice. **Update 27/04/2017** Added The Stl File For The Barbed Connector So People Don'T Forget To Do Both.
Statistics
Likes
127
Downloads
0