Makergear M2 60mm Bed Fan for V4 Hot End
Description
I Replaced The Stock 50Mm Bed Fan With A 60Mm Noctua (Nf-A6X25) - Slightly Higher Airflow, 1/3 Of The Noise - This Did Require Using A Buck Converter To Convert The Power To 12V Rather Than The 24V That Was Used For The Stock Fan. I Had Previously Been Using A Funnel Designed For The Stock Fan With A 50Mm To 60Mm Converter Attached To It, But Wanted A Better Solution For My Fan Mount. I Modified The Filament Feed From The Makergear Github Site With An Arm And Built A New Funnel Which Provided Better Airflow Than The Previous Setup. I Built This In 2 Parts So That It Could Be Adapted For Various Other Fans If Anyone Choose To Do So, Also It Helps Improve The Print. I Have Tested Several Prints With This Setup And It Works Wonderfully And Reduces The Noise Level Even Further Due To Not Being Held On By A Single Bolt Through The Extruder Fan Which Created A Lot Of Vibration Noise.
Statistics
Likes
2
Downloads
0