remix of : MINI Prop Tool by babar121
Description
Really Liked The Design Mini Prop Tool By Babar121, Thought I Would Remix It So The 8Mm Hex Runs The Full Length (Then You Have Two 8Mm Hex To Use, Should One Get Chewed Up. Slightly Flattened The Sphere Just To Reduce Printing Time A Little. (20Mm Tall Now) Works Really Well, Just About Right Amount Of Leverage (Too Much Can Be Bad For The Threads!), Great Grip. All Credit To Babar21 I Recommend Printing In Pla, As It Gives Neater Rigid Edges - Plenty Strong Enough For The Use. Abs Works, But Due To Abs Being Slippery And Does Not Quite Give Sharp Corners Etc, You May Find The Tool Slips On The Nut After Some Use. Printed Solid, Mine Came Out In About 45Min At 60Mm/S You Could Reduce Infill To About 40% But Increase Perimeters Slightly To Keep Strength. 100% Infill Recommended
Statistics
Likes
11
Downloads
0