Stir Plate
Description
This Stir Plate Body Features A Lid That Snip-Fits Into The Base With Clearance For The Height Of Two Neodymium Disc Magnets Mounted Onto The Fan That Sits On The Four Pillars Inside. Make Sure To Print The Lid With The Extruded Features Facing Up, Flat Face On Bottom. This Thing Is Designed To Enclose Specific Electronic Components Listed Below. Minor Adjustments To Mounting Holes Can Be Made With A File, Sandpaper, Tape, Glue, Etc. Part List: • Sunon Maglev Fan -- Kde1208Ptb1 (Or Other 80X80X25Mm Dc12V Fan) • Dpdt Toggle Switch -- C&K L202031Ms02Q (Press This Into The Rectangular Hole On The Back) • Potentiometer (Part Number Unknown) I Used A Logarithmic Taper Pot From A Guitar Effects Pedal. A Linear Taper Would Perform Better. Critical Dimensions: Housing Diameter (Max Width) = 24Mm Mounting Depth = 12Mm Max Height = 30Mm • Panel-Mount, 2.2Mm Barrel Plug Jack (Install This In The Circular Hole On The Back) • 1/4" Od Led (Install This In The Small Hole On The Front) • Stranded Wire • 4, 8Mm Neodymium Magnets • 1Inch Magnetic Stir Bar • 10Ohm Resistor (Optional--I Needed One To Limit The Fan Speed A Little)
Statistics
Likes
23
Downloads
0