Mount for ESCs and receiver box on electric mountain board
Description
This Part Is Intended For Holding The Speed Controllers (Escs) And Water-Proof Receiver Box In Place On An Electric Mountain Board. The Setup Of The Emtb Is Quite Standard (Trampa Holypro 35), Hobbywing Max6 Escs, And A Receiver Box (Traxxas 5624). The Most Clean Builds With These Parts Use A Cnc Shaped Carbon Plate For Fitting The Parts (Https://Goo.Gl/Cbelqq), But It Is Quite Expensive And Has No Dumping For The Escs. The Idea Here Is To Use Velcro For The Actual Mounting Of The Parts (The Strong Kind - Https://Goo.Gl/Vtc9S7). The Perimeter Of The Part Is Raised So The Velcro Does Not Show (After Installing It I See That It Doesn'T Do That Actually, But It Still Looks Good Imo) I Played With Two Options But Printed And Tested Only One (The One With The Escs On Top). [Edit:] This Board Is Used Extensively In Hard Conditions, And The Mount Holds Very Well! Access To The Receiver Box Is Good, And The Velcro Holds The Esc And Box Strongly. Bottom Line: This Design Is Proven. I Don'T Think I Have Anything To Add/Change To It. [Obsolete Note:] A Small Disclaimer, I Only Spent A Couple Of Hours On The Board With This Setup At This Point, But All Seems To Work As Planned, I'Ll Update If That Changes.
Statistics
Likes
18
Downloads
0