Kossel Pro Delta E3D V6 End Effector Version 8
Description
This Is Version 8 Of My End Effector For The Openbeam Kossel Pro And Other Delta Printers. It Uses An E3D V6 And Has Fantastic Part Cooling. Main Goals For This End Effector: -Fit An E3D V6 -Avoid Nozzle From Getting Too Far Beneath Arms -Integrated Hotend Cooling -Great Wrap Around Part Cooling -Two Piece Hotend Clamp -Standard 30Mm Fans -No Interference Between End Effector And Arms -Secure Arm Mounting -Easily Printable -Fan Duct With Ribbing To Direct Air -Fan Duct Nozzle Close To Print Nozzle Improvements From Version 5: -Improved Part Cooling Ducting For More Airflow -Two Piece Hotend Clamp -More Secure Arm Mounting- Eliminates The Round Standoff -Easier To Print- Eliminated Areas With Small Contact To The Bed -Fan Duct Body Allows For Greater Airflow -Fan Duct Body Is Further Away From Heater Block To Prevent Melting/Warping -Fan Duct With Ribbing To Direct Air -Fan Duct Nozzle Close To Print Nozzle Hardware List: 8X M3 4X4Mm Embedded Nuts (Not Standard 5.5Mm Hex Nuts - Pictured Above) M3 Screws: 1X 6Mm, 2X 8Mm, 2X 10Mm 6X 5/8" #4 Thread Rolling Screws To Mount Fans ***Print With Supports Set To 46 Degrees To Avoid Support In Hard To Reach Places ***For The Fan Duct, Set Extrusion Width To .5Mm, Layer Height To .1Mm, And Print Super Slow (30Mm/S) To Be Able To Print The Overhangs Properly With No Support. Dimensions: Arm Width: 41Mm Radius: 30Mm
Statistics
Likes
97
Downloads
0