Creality Spool adaptor
Description
Spool Adaptor To Fit The Creality Spool Arm To Prevent The Spool From Tumbling And Cause Under-Extrusion. I Made This Because When I Adjusted My Extruder Steps Per Mm, I Tested The Impact Of The Counter Drag From The Spool Which Turned Out To Cause Massive Under Extrusion. The Impact Was About 1-2Mm Of Under Extrusion, Especially When The Extruder Pulls The Filament Enough To Initiate A Spool Revolution But Then Retracts And Refeed Again, The Spool Would Bounce, Causing Quite A Pull And Lead To Incomplete Refeed. Beware That I Havent "Tested" This All That Much Yet As I Just Made One Print And Put It To Use, But So Far It Seems To Work Quite Well. If You Use This, Please Let Me Know If You Encounter Any Problems So I Can Fix It And Update The Download On Here. The Tube Part Has A Length Of 80Mm And An Inner Diameter Of 31.3Mm. The Conical End Pieces Are 45-55Mm. 09/07-2017 Added Wider Conical Nut 45-60Mm Added Threaded Tube W/O Fixed Nut (31.3Mm Inner Dia) Added Threaded Tube W/O Fixed Nut (32.7Mm Inner Dia)
Statistics
Likes
123
Downloads
0