Blower Attachment Bracket for the Back
Description
After Installing The Titan Aero, I Wanted To Move The Blower To The Back Of The Carriage So It Is Easier To Operate The Titan Extruder. This Is A Simple Plate That Uses Already Existing Threaded Holes On The Original Anet A8 Motor/Extruder Bracket. Here I Am Using A Titan Aero Carriage Bracket Made By Mcstan ( Https://Www.Thingiverse.Com/Thing:2234921 ) Which He Also Carried Over Those Two Existing Attachments. I First Had The Blower Sideways But That Didn'T Work Because It Was Hitting The Vertical Acrylic Walls. Then I Turned It 90 Degrees And After Printing So It Would Sit In The Middle Of The Mount Plate, I Saw It Wasn'T In Line With The Nozzle. So Moved It To The Outside Of One Of The Mount Legs. In My Picture You Can See Where I Still Have Half Of The Clipped Leg. But The Attached File, V3, Has This Leg Already Removed. I Also Had To Limit The Maximum X Travel So The Fan Would Not Hit The Far Acrylic Wall, But The Nozzle Still Covered The Bed All The Way. Next Is A Nozzle For This Setup... Thanks For Mcstan To Do The Harder Part Which Was The Carriage Mount For The Titan Aero!! First Update: After Printing And Installing This Duct ( Https://Www.Thingiverse.Com/Make:335412 ) From Mrblom, I Had To Do Some Tweeks... The Blower Needed To Sit Further Away From The Carriage And Higher. So Here Is V4!!
Statistics
Likes
11
Downloads
0