Gemstock Delta Printer (Rosstock Mini - Mini Kossel combination)

Description

Hello Everyone! As Promised I Have Now Uploaded All The Parts That Are Finished So Far. Mind You, This Is A Work In Progress, So I Will Be Adding And Subtracting As Needed. This Project Is Intended To Be A Full Delta Printer Design, With Lots Of Room To Upgrade, Or Deviate From Bed-Size. The Idea Came Forth Of Not Having All The Parts Needed To Build A Rosstock Mini. All The Vertical Items (Smooth Rods And Bearings To Roll Over Them) Were Available But The Horizontal Plates Were Not. Therefor I Came Up With The Idea To Use Some Other Items I Had Laying Around From Building Another Printer. For The Horizontal Bars I Have Used A Similar Setup As The Kossel Mini. Misumi Bars / Extrusions. Short Bill Of Material: 6X Smooth Rods Of 10Mm And Any Length You Want (75Cm Is What I Used) 6X 20X40 Extrusion Of Any Length (About 20+Cm Is What I Have Used) 36X 623Zz Bearings (Linear Slider, Custom Design!) Bunch Of M3 & M5 Screws Many Items Are Dependent On The Sizes You Choose Above. Belts, Bed Size, Carbon Rods, Etc. So I Will Be Working On A Design That Will Be A Guideline With Some More Defined Items And Lengths. Many Parts I Have Gotten From Older Projects, But A Printer Like This Can Easily Be Below 300 Euros If You Are Willing To Buy Some Chinese Parts. Hope You Will Find This A Nice Design, As I Have Had Lots Of Printing Fun With It Already! Stefan

Statistics

Category

Tags